24" Compact Vented Dryer
Axxis - White

Warning: To avoid risk of explosion, never use solvents or highly flammable liquids for cleaning. Incorrect cleaning may damage the dryer. Do not spray with a pressure washer. Do not use scouring agents or all-purpose cleaners. Do not use steam cleaners.

To clean the exterior: Wipe the housing with a soft cloth and soapy water only. Rinse and then dry. Wipe the control panel with a damp cloth.

To clean the interior: Wipe the drum, door seal and inside of the door with a damp cloth only.

To clean the lint filter housing: Lint and small debris may accumulate in the lower portion of the lint filter opening. The lint and small debris can be removed with a vacuum cleaner using a cleaning tool that can reach into narrow crevices.

To clean the lint filter: Run the lint filter under warm water and gently scrub with your fingertips or a soft brush. This should be done monthly. Dry with a soft cloth and reinsert into the housing.

Door may not be closed. Close the door.

Your power cord may not be plugged in. Check it and plug in the power cord if necessary.

You may be experiencing a power outage.

Power may not be flowing to the socket. Check if electricity is present at the outlet in question by using another small object that runs on electricity (e.g. hairdryer). If electricity is not present, consult an electrician.

The fuse may have blown or the circuit breaker may be tripped. Replace the fuse or reset the circuit breaker.

Dryer may not have been installed correctly. Recheck all installation instructions.

If the dryer makes thumping noises: This means the drum suspension rollers need time to warm up. This is normal and no action is required. As the suspension rollers warm up the thumping noise will decrease and should stop within 2 to 3 minutes of dryer use.

If the dryer rocks or vibrates: Dryer may not be level. Level the dryer according to the installation instructions in the Use & Care Guide. Each foot should carry approximately 25% of the total weight.

If the dryer makes a rhythmic vibrating noise:

• The laundry load may be balled up. This causes the load to bounce in the dryer. Stop the dryer, separate the items in your load and restart the dryer.
• The electric or gas line may be rattling against the dryer. Check to ensure this is not occurring.

A cycle without steam may have been selected. Choose a cycle with steam.

The water tap may not be turned on. Turn on the water tap.

The nozzle may be dirty thus causing it to not spray water adequately. Wipe the outside of the nozzle with a cloth moistened with white vinegar.

The nozzle may be blocked. Remove the nozzle using a 7/16” socket wrench. Place the nozzle into a container filled with enough white vinegar to cover the nozzle. Soak for 5 minutes, then gently scrub with a toothbrush to remove residue. Rinse the nozzle in water, dry with a soft cloth and then reinsert it back into the dryer.

The Aqua-Stop hose (if installed on your product) may have been triggered. It is triggered when there is a leak in the hose. The hose will have to be replaced if a “red dot” is seen in the Aqua-Stop window. See illustration below